Rose Electronics Orion X-series - Manual (Page 111)

APPENDICES
Orion X Installation and Operations Manual 103
Appendix A – General Specifications
This section gives the general specifications for the Orion X connectors, pinouts, cables and dimensions.
Interfaces
The different types of possible connections, and any restrictions on them, are discussed here.
DVI-D Single Link
The video interface supports the DVI-D protocol. All signals that comply to DVI-D Single Link can be
transmitted. This includes e.g. monitor resolutions such as 1920x1200@60Hz, Full HD (1080p) or 2K HD
(up to 2048x1152). Data rate is limited to 165 Mpixel/s.
USB HID
The Orion X supports a maximum of two devices with USB-HID protocol. Each USB-HID port provides a
maximum current of 100 mA.
Keyboard
Compatible with most USB keyboards. Certain keyboards with additional functions may require custom
firmware to operate. Keyboards with an integral USB Hub (e.g.Mac keyboards) are also supported.
Mouse
Compatible with most 2-button, 3-button and scroll mice.
Other USB-HID devices
The proprietary USB emulation also supports certain other USB-HID devices, such as specific touch
screens, graphic tablets, barcode scanners or special keyboards. Support cannot be guaranteed,
however, for every USB-HID device.
Note: Only two USB-HID devices are supported concurrently, such as keyboard and mouse or keyboard
and touch screen. A hub is allowed, but it does not increase the number of HID devices allowed.
RJ45 (Network)
The communication of the Cat X devices requires a 1000BASE-T connection.
The cabling is to be done according to EIA/TIA-568-B (1000BASE-T) with RJ45 connectors at both ends.
All of the four wire pairs are used in both directions. The cabling is suitable for a full duplex operation. For
the cable connection to a source (computer, CPU), a crossed network cable (cross cable) must be used.
RS-232 (Serial)
The communication takes place with a transmission speed of up to 115.2 KBaud, regardless of the file
format. The transmission takes place with eight data bits and a stop bit, but without a parity bit. Limited
hardware handshake (DSR) is possible.
RJ45 (Interconnect)
The communication of the Cat X devices requires a 1000BASE-T connection.
Connector wiring must comply with EIA/TIA-568-B (1000BASE-T), with RJ45 connectors at both ends. All
four cable wire pairs are used.