Kyocera Ecosys m2040dn - Manual (Page 163)

5-3
Operation on the Machine > Loading Originals
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned. (Only on models with a duplex scanning function.)
The document processor supports the following types of originals.
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
1 Open the original table and then adjust the original width
guides.
Weight 50 to 160 g/m 2
(duplex: 50 to 160 g/m 2 ) *1
*1 Only on models with a duplex scanning function.
Sizes Maximum Folio (Legal) to Minimum A6 (Statement)
No. of sheets Plain paper (80 g/m 2 ): 50 sheets (Mixed size originals: 50 sheets)
Thick (120 g/m 2 ): 25 sheets
IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.