Access-list name <word> set mac-mode mac sa, Access-list name <word> set mac-mode mac da, Access-list name <word> set mac-mode ether-type – PLANET WGSW-5242 User Manual
Page 252: Access-list name <name> set portlist
User’s Manual of WGSW-5242
252
access-list name <WORD> set mac-mode mac SA
Description:
This command specifies a source mac address.
Syntax:
access-list name <WORD> set mac-mode mac SA
<mac-addr> <mask-addr>
Parameters:
<mac-addr>
<mask-addr>
Mode
Global Config
access-list name <WORD> set mac-mode mac DA
Description:
This command specifies a destination mac address.
Syntax:
access-list name <WORD> set mac-mode mac DA
<mac-addr> <mask-addr>
Parameters:
<mac-addr>
<mask-addr>
Mode
Global Config
access-list name <WORD> set mac-mode ether-type
Description:
This command specifies the ether type of the packet.
Syntax:
access-list name <WORD> set mac-mode ether-type
{ipv4|ARP|xns}
Parameters:
{ipv4|ARP|xns}
Mode
Global Config
access-list name <name> set portlist
Description:
This command is used to specify an acl entry to be work on a list of ports.
Syntax:
access-list name <name> set portlist
<LINE | port_id>
Parameters:
<LINE | port_id>
Mode
Global Config