PLANET WGSW-5242 - Manual (Page 26)

User’s Manual of WGSW-5242
26
2. INSTALLATION
This section describes the hardware features and installation of the Managed Switch on the desktop or rack mount. For easier
management and control of the Managed Switch, familiarize yourself with its display indicators, and ports. Front panel
illustrations in this chapter display the unit LED indicators. Before connecting any network device to the Managed Switch, please
read this chapter completely.
2.1 Hardware Description
2.1.1 Switch Front Panel
The unit front panel provides a simple interface monitoring the switch. Figure 2-1 shows the front panel of the Managed
Switches.
WGSW-5242 Front Panel
Figure 2-1
WGSW-5242 front panel.
■ Fast Ethernet TP interface (Port-1 ~ Port-48)
10/100ase-TX Copper, RJ-45 Twist-Pair: Up to 100 meters.
■ Gigabit TP interface (Port-49 ~ Port-52)
10/100/1000Base-T Copper, RJ-45 Twist-Pair: Up to 100 meters.
■ Gigabit SFP slots ( Shared with 10/100/1000Base-T Port-51 and Port-52)
1000Base-SX/LX mini-GBIC slot, SFP (Small Factor Pluggable) transceiver module: From 550 meters (Multi-mode fiber),
up to 10/30/50/70/120 kilometers (Single-mode fiber).
■ Reset button
At the left of front panel, the reset button is designed for reboot the Managed Switch without turn off and on the power. The
following is the summary table of Reset button functions :
Reset Button Pressed and Released Function
< 5 sec
: System reboot Reboot the Managed Switch
> 10 sec
: Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
Default Password:
admin
Default IP Address: 192.168.0.100
Subnet Mask:
255.255.255.0
Default Gateway:
192.168.0.254