PLANET WGSW-5242 - Manual (Page 261)

User’s Manual of WGSW-5242
261
Parameters:
<A.B.C.D>
<mac-address>
<port-id>
<vlan-id>
Mode
Global Config
6.3.23 Loop_detect Command
Loop_detect enable
Description:
This command is used to enable port self-loop detection.
Syntax:
loop_detect enable
Mode
Global Config
loop_detect disable
Description:
This command is used to disable port self-loop detection.
Syntax:
loop_detect disable
Mode
Global Config
loop_detect recovertime
Description:
This command is used to set the recover time.
Syntax:
loop_detect recovertime
<0…65535>
Parameters:
<0…65535>
Mode
Global Config
loop detect trytorecover
Description:
This command is used to try to recover all the selfloop port immediately