PLANET WNAP-1260 - Manual (Page 15)

User’s Manual of WNAP-1260
-7-
Software Features
Operation Mode
AP/Router
Repeater
Client
(Switchable by H/W)
Wireless Mode
AP, Client, WDS PTP, WDS PTMP, Repeater (WDS+AP), Universal
Repeater (AP+Client)
Encryption Security
WEP (64/128-bit) encryption security
WPA / WPA2 (TKIP/AES)
WPA-PSK / WPA2-PSK (TKIP/AES)
Provide wireless LAN ACL (Access Control List) filtering
Wireless MAC address filtering up to 16 entries
Support WPS (Wi-Fi Protected Setup)
Wireless Security
Enable/Disable SSID Broadcast
WMM(Wi-Fi Multimedia): 802.11e Wireless QoS
Multiple SSID: up to 4
Wireless Isolation: Enable it to isolate each connected wireless clients, to
let them cannot access mutually.
IAPP(Inter Access Point Protocol): 802.11f Wireless Roaming
Wireless Advanced
Provide Wireless Statistics
Max. Clients
Wire: 253
Wireless: 32
Internet Connection
Type
Shares data and Internet access for users, supporting following internet
access:
 Dynamic IP
 Static IP
 PPPoE
 PPTP
 L2TP
NAT firewall with SPI (Stateful Packet Inspection)
Built-in NAT server supporting Port Forwarding, Port Triggering, and DMZ
Built-in firewall with IP address/ MAC address/ Port/ URL filtering Firewall
Support ICMP-FLOOD, UDP-FLOOD, TCP-SYN-FLOOD filter, DoS
protection
Routing Protocol Static Routing
VPN Pass-through SIP ALG, PPTP, L2TP, IPSec
Built-in DHCP server supporting static IP address distributing
Support UPnP, Dynamic DNS LAN
Support IGMP Proxy
Web-based (HTTP) management interface
SNTP time synchronize
System
Management
Easy firmware upgrade
Standards Conformance
IEEE Standards IEEE 802.11n (2T2R, up to 300Mbps)