Hardware installation – PLANET WNAP-1260 User Manual
Page 28
Advertising
User’s Manual of WNAP-1260
-20-
4.5. Hardware Installation
STEP 1:
Make sure the operation mode by hardware switch is Repeater Mode (Default
Setting).
STEP 2:
Plug WNAP-1260 into the wall outlet, and wait about 40 seconds for
WNAP-1260 to boot up.
STEP 3:
Using WPS Button to establish connection with AP:
(1) In the existing Wireless Router or AP, push the WPS Button within 2 minutes.
(2) In the WNAP-1260, push the WPS Button from the side panel within 2
minutes.
(3) Wait for the connection being established. If connection is successfully
established, the “WPS” LED will light for 5 minutes.
Advertising