Client mode configuration – PLANET WNAP-1260 User Manual
Page 42
Advertising
User’s Manual of WNAP-1260
-34-
5.5. Client Mode Configuration
Step 1 Set the three-way switch on the side panel to Client after WNAP-1260 is powered on. Log in to
the configuration page after the system is started.
Step 2 Click Setup Wizard in the navigation bar on the left pane of the page. Click Site Survey to
search for the wireless network you want to connect.
Figure 5-16
Step 3 Enter encryption information of the selected wireless network. Click Next.
Figure 5-17
Step 4 Check Synchronize Wireless Universal Repeater's And Uplink AP's SSID And Security
Options if you want to sync the SSID & Security key. Click Finish to complete the settings.
Advertising