Configure the ip address manually – PLANET WNAP-1260 User Manual
Page 26
User’s Manual of WNAP-1260
-18-
5) Choose Obtain an IP address automatically, and Obtain DNS server address automatically
as shown in the figure below. Then click OK to save your settings.
Figure 4-4
4.4.2. Configure the IP address manually
If you are sure the DHCP server of WNAP-1260 is disabled (the default setting of
AP Mode
and
Client
Mode
), you can configure the IP address manually. The IP address of your PC should be
192.168.1.xxx (the same subnet of the IP address of WNAP-1260, and "xxx" is any number from 1 to
254), Subnet Mask is 255.255.255.0, and the Gateway is 192.168.1.253 (The default IP address of
WNAP-1260)
1) Continue the settings from the last figure, select Use the following IP address radio button.
2) If the LAN IP address of the WNAP-1260 is 192.168.1.253, enter IP address 192.168.1.x (x is
from 1 to 254), and Subnet mask 255.255.255.0.
3) Enter the LAN IP address of the WNAP-1260 (the default IP is 192.168.1.253) into the Default
gateway field.
4) Select Use the following DNS server addresses radio button. In the Preferred DNS Server field,
you can enter the DNS server IP address provided by your local ISP. Then click OK to save your
settings.