Network settings, Lan interface settings – PLANET WNAP-1260 User Manual
Page 58
User’s Manual of WNAP-1260
-50-
Figure 7-3
Bridge Mode: The interface on its case is an LAN interface. Users can connect WNAP-1260 and
the PC using an RJ45 cable or a wireless network card.
Router Mode: Computers can connect to WNAP-1260 in a wireless way only.
7.6. Network Settings
Click LAN Interface Settings and the extended navigation menu is shown as follows:
Click a submenu to perform specific parameter configurations.
7.6.1. LAN Interface Settings
Choose Network Settings > LAN Interface Settings and the LAN Interface Settings page is
displayed.
Figure 7-4
You can modify the IP address and IP subnet mask of the LAN port as required.
If you change the default IP address, you must use the new IP address to log in to
the Web configuration page of the router and the default gateway of all hosts in the
LAN must be set to the new IP address for internet access.
The subnet mask of all hosts in the LAN must be the same as the subnet mask
specified in the LAN Interface Settings page.