PLANET WNAP-1260 - Manual (Page 69)

User’s Manual of WNAP-1260
-61-
7.7.4. WPS Setup
WPS refers to Wi-Fi Protected Setup.
You can use WPS to establish wireless connection in a quick and secure way if the uplink AP or
terminal (for example, the network adapter) has the WPS function. It is suggested to first configure
wireless encryption for the uplink AP. If you change the wireless encryption mode after having
establishing wireless connection using WPS, you must use WPS to establish wireless connection
again. Note that if the wireless client does not support WPS you must manually configure the wireless
client (such as SSID, security mode, and password) to make it have the same SSID and wireless
security settings as the router.
The following describes how to configure WPS for the AP mode.
 Using the WPS Button
In the AP mode with WDS disabled, press the WPS button on the side panel of WNAP-1260 and the
WPS button on the client device. WNAP-1260 can perform WPS encrypted connection to the downlink
client device.
Figure 7-18
 Using the Web Page
You can perform WPS settings using the Web page for configuration.
Choose Wireless Settings > WPS Setup to display the WPS Setup page.
 PBC mode
Step 1 Select Push Button and click Start PBC. WPS encrypted connection starts.
Figure 7-19
Step 2 Press the WPS button on the network adapter or click the PBC button in the network adapter
configuration tool within 2 minutes to start WPS connection.