PLANET WNAP-1260 - Manual (Page 76)

User’s Manual of WNAP-1260
-68-
 Set Interval: Set the interval for traffic statistics.
 Stop: If you click this button, this page always displays statistics information that was refreshed for
the last time and it is not refreshed any more.
Click Connection Status in the System Status page, and the Connection Status page is displayed.
This page displays current connection information of WNAP-1260.
The following takes WAN connection of DHCP as an example.
Figure 8-3
 Release: Click the button and WNAP-1260 sends a request to the ISP for releasing the IP address,
the subnet mask, the default gateway, and DNS server settings.
 Renew: Click the button and WNAP-1260 dynamically obtains an IP address, a subnet mask, the
default gateway, and DNS server settings from the ISP. The information will be displayed in this
page.
For details of WAN connection modes, refer to section “Choose Network Settings > LAN Interface
Settings and the LAN Interface Settings page is displayed.
Figure 8-6
You can modify the IP address and IP subnet mask of the LAN port as required.
If you change the default IP address, you must use the new IP address to log in to the Web
configuration page of the router and the default gateway of all hosts in the LAN must be set
to the new IP address for internet access. The subnet mask of all hosts in the LAN must be
the same as the subnet mask specified in the LAN Interface Settings page.