PLANET WNAP-1260 - Manual (Page 79)

User’s Manual of WNAP-1260
-71-
8.6. Network Settings
Click Wired Network Settings and the extended navigation menu is shown as follows:
Click a submenu to perform specific parameter configurations.
8.6.1. LAN Interface Settings
Choose Network Settings > LAN Interface Settings and the LAN Interface Settings page is
displayed.
Figure 8-6
You can modify the IP address and IP subnet mask of the LAN port as required.
If you change the default IP address, you must use the new IP address to log in to the Web
configuration page of the router and the default gateway of all hosts in the LAN must be
set to the new IP address for internet access. The subnet mask of all hosts in the LAN
must be the same as the subnet mask specified in the LAN Interface Settings page.
8.6.2. WAN Interface Settings
Choose Network Settings > WAN Interface Settings and the WAN Interface Settings page is
displayed.
The router supports 5 modes of WAN connection, including Dynamic IP (DHCP), Static IP, PPPoE,
PPTP, and L2TP. Select the WAN connection you use. Contact your ISP if you do not know your WAN
connection mode.
(1) Dynamic IP (DHCP)
If you select dynamic IP (DHCP), WNAP-1260 automatically obtains the IP address from the ISP
automatically. Select DHCP when the ISP does not provide any IP network parameters. See the
following figure: