ProSoft Technology 5201-MNET-101S User Manual
Iec-101 slave, Protocol manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Start Here
- 101S Protocol Configuration
- [IEC-870-5-101 Port 0]
- Enabled
- Time DB Offset
- Disable Time Sync Events
- Data Link Address Value
- Data link address length
- Common Address of ASDU Val
- Common Address of ASDU Len
- Inform. Object Address Len
- Cyclic Data Transmission
- Select/Operate Timeout
- Use ACTTERM with Set Point
- Use ACTTERM with Step
- Single char ACK F0, 1 or 3
- Single char ACK C1 or C2
- Maximum ASDU Resp Len
- Cause of Trans(mission) Octets
- Freeze Start Type
- Interval for Freeze
- Set Priority Queues
- Event Priority
- Cyclic Set IV Time - PLX 101S
- IV Check Delay Time
- IV Fail Count
- Event Scan Delay
- Scan Events
- Time Type
- Use Balanced Mode
- Retry Count
- Response Timeout
- Baud Rate
- Parity
- RTS On
- RTS Off
- Minimum Delay
- Receive Timeout
- Hardware Handshaking
- [IEC-870-5-101 Database]
- [M_SP_NA_1]
- [M_DP_NA_1]
- [M_ST_NA_1]
- [M_BO_NA_1 104]
- [M_ME_NA_1]
- [M_ME_NB_1]
- [M_ME_NC_1]
- [M_IT_NA_1]
- [C_SC_NA_1]
- [C_DC_NA_1]
- [C_RC_NA_1]
- [C_BO_NA_1 104]
- [C_SE_NA_1]
- [C_SE_NB_1]
- [C_SE_NC_1]
- Group Codes
- [IEC-870-5-101 Port 0]
- Gateway Communication Ports
- Diagnostics and Troubleshooting
- Reference
- Product Specifications
- IEC-60870-5-101 Slave Protocol Implementation
- Data Flow Between the gateway and External Host
- General Parameter Configuration
- Monitor Direction and Control Direction
- Using Monitor Points
- Using Control (Command) Points
- Events
- Command Block Functionality
- Introduction
- Configuration
- Command Block List
- Event Data Command Block
- Set Time Command Block
- Get Time Command Block
- Get Event Buffer Counts Command Block
- Slave Error and Status
- IEC 60870-5-101 Slave Interoperability Statement
- System or Device
- Network Configuration
- Physical Layer
- Link Layer
- Application Layer
- Selection of Standard ASDUs
- Type Identifier and Cause of Transmission Assignments
- Basic Application Functions
- Station Initialization
- Cyclic Data Transmission
- Read Procedure
- Spontaneous Transmission
- Double Transmission of Information Objects
- Station Interrogation
- Clock Synchronization
- Command Transmission
- Transmission of Integrated Totals
- Parameter Loading
- Parameter Activation
- Test Procedure
- File Transfer
- Background Scan
- Aquisition of transmission delay
- 101S v3 Database Design Forms
- Support, Service & Warranty
- How to Contact Us: Technical Support
- Return Material Authorization (RMA) Policies and Conditions
- LIMITED WARRANTY
- What Is Covered By This Warranty
- What Is Not Covered By This Warranty
- Disclaimer Regarding High Risk Activities
- Intellectual Property Indemnity
- Disclaimer of all Other Warranties
- Limitation of Remedies **
- Time Limit for Bringing Suit
- No Other Warranties
- Allocation of Risks
- Controlling Law and Severability