Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 104)

Studio Display
073-00335-A | 104 © 2022 Apple Inc. All rights reserved.
Reassembly
2. Insert the Torx T5 bit into
the 10–34 Ncm adjustable
torque driver. Set the torque
value to 14.5 Ncm. Use the
adjustable torque driver and
Torx T5 bit to fully reinstall
the four T5 screws in the
order shown.
3. Use the T5 screwdriver to
partially reinstall one T5
grounding screw (923-
07145) into the power cord
port as shown. Keep the
Torx T5 bit in the 10–34
Ncm adjustable torque
driver. Set the torque
value to 25 Ncm. Use the
adjustable torque driver
and Torx T5 bit to fully
reinstall the T5 screw.
1. Position the power cord
port in the housing. Use the
T5 screwdriver to partially
reinstall four T5 screws
(923-07146) into the
power cord port in the order
shown.
Power Cord Port | Reassembly
4. Install the 4 mm alignment
pin in the upper left screw
hole in the left side of the
housing (1). Then install the
3 mm alignment pin in the
upper right screw hole (2).