Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 19)

Studio Display
073-00335-A | 19 © 2022 Apple Inc. All rights reserved.
Display (Stand) | Before You Begin
Damaged wheel New wheel
The adhesive cutter has
replacement wheels.
You will likely need to
use several wheels
because when a wheel is
chipped, dented, broken,
or no longer flat, you
must replace it. Using
a damaged wheel can
damage the polyester
tape on the display.
Caution
• To remove the display, you must cut adhesive strips that attach the display to the rear housing.
Each strip has a foam layer surrounded by two adhesive layers. You’ll use the adhesive cutter to
cut the adhesive strips and will be cutting mostly through the foam layer.
• For models configured with the VESA mount adapter, refer to the Display (VESA mount adapter)
removal and reassembly instructions.
Important
This procedure requires System Configuration. To perform System Configuration you will need the
following:
• The latest version of Apple Service Utility installed on a Mac running macOS 12.4 or later
• Internet access
• A USB-C charge cable or a USB-A to USB-C cable. The USB-C cable must support both power
and data. Don’t use Thunderbolt 3 cables.
After you’ve completed all removal and reassembly steps and configured the Mac with Apple
Service Utility, learn how to initiate the System Configuration process at support.apple.com/
self-service-repair .
Caution