Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 119)

Studio Display
073-00335-A | 119 © 2022 Apple Inc. All rights reserved.
9. Ensure that the torque value
is still set to 3.5 Nm. Use the
adjustable torque wrench
and 20IP bit to partially
reinstall the two 20IP screws
to 3.5 Nm as shown.
8. Remove the two alignment
pins. Then use the
adjustable torque wrench
and 20IP bit to partially
reinstall two 20IP screws
(452-06708) as shown.
Tilt-Adjustable Stand | Reassembly
Note: The alignment pins
may get stuck. If they do,
use a flathead screwdriver
to remove the alignment
pins.