Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 122)

Studio Display
073-00335-A | 122 © 2022 Apple Inc. All rights reserved.
Note: If the alignment pins
do not easily fit in, loosen
the other three 20IP screws.
Tilt- and Height-Adjustable Stand | Removal
Removal
1. Insert the 20IP bit into
the 2.5–25 Nm adjustable
torque wrench. Remove
the two 20IP screws
(452-07329) in the order
shown. Then install the two
alignment pins for stand and
VESA mount adapter in the
same order.
2. Use the adjustable torque
wrench and 20IP bit to
remove the remaining three
20IP screws in the order
shown:
Before you begin the removal procedure, position the support wedge to keep the display in place.
Ensure that the support wedge is between the enclosure and the stand to keep the display in
place.
Important
• (452-07330) (1)
• (452-07329) (2, 3)