Siemens TC63 - Manual (Page 146)

TC63 AT Command Set
7.5 ATD><n>
s
TC63_ATC_V00.490 Page 146 of 501 5/24/05
Confidential / Draft - Do not copy
7.5 ATD><n> Mobile originated call from active memory using index
number
Syntax
Command Description
TA attempts to set up an outgoing call to the stored number. The termination character ";" is mandatory since
dialing from a phonebook is only supported for voice calls and for sending *# codes of Supplementary Services
or other functions.
Parameter Description
Integer type memory location in the range of locations available in the selected memory, i.e. the index number
returned by
AT+CPBR
.
String of GSM modifiers:
I Activates CLIR (disables presentation of own phone number to called party)
i Deactivates CLIR (enables presentation of own phone number to called party)
Notes
• This command may be aborted generally by receiving a character during execution. Abortion is not possible
during some states of connection setup such as handshaking.
• The command is not applicable to data calls. Any attempt to dial a data call number from
<n>
causes the
result code "NO CARRIER" to appear.
• Parameter
<mgsm>
only if no *# code is within the dialing string.
Exec Command
ATD> <n>
[
<mgsm>
];
Response(s)
ERROR
+CME ERROR: <err>
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
When TA returns to command mode after call release:
OK
If successfully connected:
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 % % § % % § § ! ! !
<n>
(num)
<mgsm>
(str)