Siemens TC63 - Manual (Page 152)

TC63 AT Command Set
7.11 AT^SHUP
s
TC63_ATC_V00.490 Page 152 of 501 5/24/05
Confidential / Draft - Do not copy
7.11 AT^SHUP Hang up call(s) indicating a specific GSM04.08 release
cause
Syntax
Command Description
The write command serves to end one specific call or all calls known to the ME, indicating a specific GSM04.08
release cause specified by the user. The command can be used for voice, fax and data calls in any call status
(i.e. any calls listed by
AT+CLCC
).
Parameter Description
release cause
Release cause from GSM04.08 to be indicated to the network.
The TC63 will release the selected connection(s) with release cause indication "cause" and location "user" (0)
in the "disconnect" protocol message to the GSM Network. It depends on the network whether or not the release
cause will be forwarded to the remote party.
1
send GSM04.08 release cause "unassigned (unallocated) number"
16 send GSM04.08 release cause "Normal call clearing "
17 send GSM04.08 release cause "User busy "
18 send GSM04.08 release cause "No user responding "
27 send GSM04.08 release cause "Destination out of order "
31 send GSM04.08 release cause "Normal, unspecified"
call number
The "call number" is an optional index into the list of current calls available via
AT+CLCC
. AT command
AT^SHUP
will terminate the call identified by the specified call number. The default call number "0" is not assigned to any
call, but signifies "all calls". As "0" is the default value, it may be omitted.
With
AT^SHUP
, Calls will be terminated regardless of their current call status, which may be any of the states
allowed by
AT+CLCC
.
[0] terminate all known calls
1...7 terminate the specific call number
<cn>
Test Command
AT^SHUP=?
Response(s)
OK
Write Command
AT^SHUP= <cause>
[,
<cn>
]
Response(s)
ERROR
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
Siemens % % % % % % % ! ! !
<cause>
(num)
<cn>
(num)