Siemens TC63 - Manual (Page 55)

TC63 AT Command Set
2.14 AT^SCFG
s
TC63_ATC_V00.490 Page 55 of 501 5/24/05
Confidential / Draft - Do not copy
Unsolicited Result Codes
URC 1
^SCFG: "AutoExec", <AutoExecState> , <AutoExecType> , <AutoExecIndex> ,
<AutoExecMode> , <AutoExecATC>
If the event specified with
<AutoExecType>
occurs and the related AT command line is executed this URC
is issued.
URC 2
^SYSSTART AIRPLANE MODE
This URC is issued each time the Airplane mode is activated, no matter whether Airplane mode is set with
parameter
<map>
="on" or
<mapos>
="on". The URC notifies the user that only the AT commands supported
in Airplane mode are accessible. After leaving the Airplane mode the URC "
^SYSSTART
" indicates that the
ME has returned to Normal mode and the full set of AT commands is accessible again.
Write Command
Configuration of URC "
^SLCC
" Call Status Indication
AT^SCFG=
"URC/CallStatus/SLCC"[,
<sucs>
]
Response(s)
^SCFG:
"URC/CallStatus/SLCC",
<sucs>
OK
ERROR
+CME ERROR
Write Command
URC indication in datamode via Ring line:
AT^SCFG=
"URC/Datamode/Ringline"[,
<udri>
]
Response(s)
^SCFG:
"URC/Datamode/Ringline",
<udri>
OK
ERROR
+CME ERROR
Write Command
URC indication via Ring line:
AT^SCFG=
"URC/Ringline"[,
<uri>
]
Response(s)
^SCFG:
"URC/Ringline",
<uri>
OK
ERROR
+CME ERROR
Write Command
Duration of active RING line for URC indications:
AT^SCFG=
"URC/Ringline/ActiveTime"[,
<urat>
]
Response(s)
^SCFG:
"URC/Ringline/ActiveTime",
<urat>
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
! % % % % % % § § !