Siemens TC63 - Manual (Page 426)

TC63 AT Command Set
18.13 AT^SNFO
s
TC63_ATC_V00.490 Page 426 of 501 5/24/05
Confidential / Draft - Do not copy
Notes
•
<outCalibrate>
specifies the amount of volume of each
<outStep>
. The range of each
<outCali-
brate>
is up to 65535, but will be suppressed to 32767. A value above
<outCalibrate>
= 65535 will cause
an error.
• The range of
<sideTone>
is up to 65535, but will be suppressed to 32767. A value above
<sideTone>
=
65535 will cause an error.
• Any change to
<outStep>
takes effect in audio modes 2 to 6. That is, when you change
<outStep>
and
then select another mode with
AT^SNFS
, the same step will be applied. Nevertheless, the sound quality and
the amount of volume are not necessarily the same, since all remaining audio parameters can use different
values in either mode.
• Audio mode 1 is fixed to
<outStep>
=4. In this mode, any attempt to change
<outStep>
or other parameters
returns an error.
• The value of
<outStep>
is stored non-volatile when the ME is powered down with
AT^SMSO
or reset with
AT+CFUN
=x,1. Any other parameters changed with
AT^SNFO
need to be saved with
AT^SNFW
for use after
restart. See also
AT^SNFD
for details on restoring factory defaults.
• The values of
<outStep>
can also be changed with
AT^SNFV
and
AT+CLVL
.
• CAUTION! When you adjust audio parameters avoid exceeding the maximum allowed level. Bear in mind that
exposure to excessive levels of noise can cause physical damage to users!