Siemens TC63 - Manual (Page 67)

TC63 AT Command Set
3.1 AT+CMER
s
TC63_ATC_V00.490 Page 67 of 501 5/24/05
Confidential / Draft - Do not copy
Parameter Description
0 (&F) Discard "
+CIEV
" and "
^SLCC
" URCs.
1 Discard "
+CIEV
" and "
^SLCC
" URCs when TA-TE link is reserved, e.g. in
online data mode. Otherwise they are forwarded directly to the TE.
2 Buffer "
+CIEV
" and "
^SLCC
" URCs in the TA while TA-TE link is reserved, e.g.
in online data mode, and flush them to the TE afterwards. Otherwise they are
forwarded directly to the TE.
3 Forward "
+CIEV
" and "
^SLCC
" URCs directly to the TE. If TC63 is in online
data mode, URCs are signaled via sending BREAK (100ms) and stored in a
buffer. Once it is back in command mode e.g. after
+++
was entered, all URCs
stored in the buffer will be output.
0 (&F) Keypad event reporting is not supported by TC63.
0 (&F) Display event reporting is not supported by TC63.
0 (&F) Disable indicator event reporting.
2 Enable indicator event reporting.
0 (&F) TA buffer of URCs defined within this command is cleared when
<mode>
1..3
is entered.
Name of indicator; for a list of all supported indicators please refer to
AT+CIND
and
AT^SIND
.
Value of indicator; for a list of all values for the supported indicators please refer to
AT+CIND
and
AT^SIND
.
Note
• If the ME operates on different instances (MUX channels 1, 2, 3 or ASC0/ASC1) avoid different settings for
routing and indicating SMS. For example, if messages shall be routed directly to one instance of the TE (set
with
AT+CNMI
,
AT^SSDA
), it is not possible to activate the presentation of URCs with
AT+CMER
or
AT+CNMI
on another instance. Any attempt to activate settings that conflict with existing settings on another interface,
will result in CME ERROR, or accordingly CMS ERROR.
<mode>
(num)
<keyp>
(num)
<disp>
(num)
<ind>
(num)
<bfr>
(num)
<indDescr>
(str)
<indValue>
(num)