Siemens TC63 - Manual (Page 288)

TC63 AT Command Set
11.10 AT+CGQMIN
s
TC63_ATC_V00.490 Page 288 of 501 5/24/05
Confidential / Draft - Do not copy
11.10 AT+CGQMIN Quality of Service Profile (Minimum acceptable)
Syntax
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context.
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification parameter,
<cid>
.
A special form of the set command,
AT+CGQMIN
=
<cid>
causes the minimum acceptable profile for context
number
<cid>
to become undefined. In this case no check is made against the negotiated profile.
AT&F
and
ATZ
will undefine the minimum QoS profiles of every context which is not active or not online.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Test Command
AT+CGQMIN=?
Response(s)
+CGQMIN: <PDP_type>
, (list of supported
<precedence>
s), (list of supported
<delay>
s), (list of
supported
<reliability>
s), (list of supported
<peak>
s), (list of supported
<mean>
s)
OK
ERROR
+CME ERROR
Read Command
AT+CGQMIN?
Response(s)
[+CGQMIN:
<cid>
,
<precedence>
,
<delay>
,
<reliability>
,
<peak>
,
<mean>
]
[+CGQMIN: ...]
OK
ERROR
+CME ERROR
Write Command
AT+CGQMIN=
[
<cid>
[,
<precedence>
[,
<delay>
[,
<reliability>
[,
<peak>
[,
<mean>
]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 % % % % % % % ! % !
<cid>
(num)