Siemens TC63 - Manual (Page 435)

TC63 AT Command Set
18.19 AT^SRTC
s
TC63_ATC_V00.490 Page 435 of 501 5/24/05
Confidential / Draft - Do not copy
Parameter Description
Type of ring tone. You have a choice of 7 different ring tones and melodies. All will be played from the audio
output selected with the
AT^SNFS
command.
<type>
=0 is only intended for muting.
0 Mutes the currently played tone immediately.
1 Sequence 1
2 Sequence 2
3 (D) Sequence 3
4 Sequence 4
5 Sequence 5
6 Sequence 6
7 Sequence 7
Volume of ring tone, varies from low to high
0
(D) Mute
1 Very low
2 Identical with 1
3 Low
4 Identical with 3
5 Middle
6 Identical with 5
7 High
Status of test ringing. Indicates whether or not a melody is currently being played back for testing
0
Switched off
1 Switched on
Notes
• Before first using ring tones note that the following settings apply:
We have chosen to let you decide your own preferences when you start using ring tones. Therefore, factory
setting is
AT^SRTC
=3,0,0 (ring tones are muted). To activate ring tones for the very first time, first enter the
write command and simply change the volume. After applying a firmware update the volume and type
selected before the firmware update will be preserved.
• The test ringing signal cannot be activated while an MTC is ringing (ERROR).
• If an MTC arrives during test playback, test ringing will be deactivated and "normal" ringing reactivated
(RING). Likewise, an MOC will also stop test ringing.
• If no optional parameter is entered, the old value will be kept.
<type>
(num)
<volume>
(num)
<status>
(num)