Siemens TC63 - Manual (Page 56)

TC63 AT Command Set
2.14 AT^SCFG
s
TC63_ATC_V00.490 Page 56 of 501 5/24/05
Confidential / Draft - Do not copy
Parameter Description
AutoExec Command
This parameter serves to switch the Autoexec function on or off.
If it is switched off (
<AutoExecCmd>
=0), parameters following
<AutoExecIndex>
are ignored and all settings
at the given index are restored to their default values.
Value will be saved while switching off the TC63 via AT commands (e.g.
AT+CFUN
or
AT^SMSO
) and restored
on next power up.
“0“
Disable automatic execution of the AT command(s) specified with
<AutoEx-
ecATC>
at a given
<AutoExecIndex>
.
“1“ Enable automatic execution of the AT command(s) specified with
<AutoExe-
cATC>
at a given
<AutoExecIndex>
. Not allowed for
<AutoExecType>
=0
(DTR line activation) while multiplex mode is active, refer to
AT+CMUX
.
AutoExec Event Type
This parameter selects the kind of event used to automatically launch the AT command(s) specified with
<AutoExecATC>
.
Value will be saved while switching off the TC63 via AT commands (e.g.
AT+CFUN
or
AT^SMSO
) and restored
on next power up.
“0“
Autoexec activity is driven by ASC0 DTR line activation (OFF-ON transition).
“1“ Autoexec activity is timer driven. To specify the time span use
<AutoExecPe-
riod>
.
AutoExec Command Index
This parameter specifies the command storage index. The following table shows the index ranges supported for
each variant of
<AutoExecType>
.
Value will be saved while switching off the TC63 via AT commands (e.g.
AT+CFUN
or
AT^SMSO
) and restored
on next power up.
AutoExec Command Mode
0...255
This parameter specifies details regarding the behavior of the TC63 when the AT command starts to be exe-
cuted.
Value is interpreted as a bit field, unused bits are reserved for future use (RFU) and shall be set to 0.
When a call is released by an Autoexec activity, no release indication may be issued on the first logical channel.
If during a data call the TC63 temporarily enters command mode via
+++
no AT command will be executed if
<AutoExecMode>
specifies 'Ignore ongoing calls'.
Value will be saved while switching off the TC63 via AT commands (e.g.
AT+CFUN
or
AT^SMSO
) and restored
on next power up.
<AutoExecCmd>
(str)(+CSCS)
<AutoExecType>
(str)(+CSCS)
<AutoExecIndex>
(str)(+CSCS)
<AutoExecType>
value
<AutoExecType>
event Valid Indices
0 Autoexec activity is driven by ASC0 DTR
line activation
0
1 Autoexec activity is timer driven. 0-2
<AutoExecMode>
(str)(+CSCS)