Siemens TC63 - Manual (Page 31)

TC63 AT Command Set
2.2 AT&V
s
TC63_ATC_V00.490 Page 31 of 501 5/24/05
Confidential / Draft - Do not copy
2.2 AT&V Display current configuration
AT&V
returns the current parameter setting. The configuration varies depending on whether or not PIN authen-
tication has been done and whether or not Multiplex mode is enabled (see
AT+CMUX
).
Syntax
Parameter Description
[0] Profile number
Notes
• The value of \Q (flow control) is also determined by the
AT+IFC
command. In case the value set by
AT+IFC
cannot be represented by a \Q equivalent, \Q255 will be displayed.
• The parameters of
AT^SMGO
can only be displayed after the SMS data from the SIM have been read success-
fully for the first time. Reading starts after successful SIM authentication has been performed, and may take
up to 30 seconds depending on the SIM used. While the read process is in progress, an attempt to read the
parameter will result in empty values.
• The parameter of
AT+CSDH
will only be displayed in SMS text mode, see
AT+CMGF
.
Exec Command
AT&V
[
<value>
]
Response(s)
ACTIVE PROFILE:
... (see Section
2.2.1 , AT&V responses )
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 ! % § % % § § ! % !
<value>
(num)