Siemens TC63 - Manual (Page 273)

TC63 AT Command Set
11.4 AT+CGAUTO
s
TC63_ATC_V00.490 Page 273 of 501 5/24/05
Confidential / Draft - Do not copy
11.4 AT+CGAUTO Automatic response to a network request for PDP
context activation
Syntax
Command Description
The test command returns the values of
<n>
supported by the MT as a compound value.
The write command disables or enables an automatic positive response (auto-answer) to the receipt of a
Request PDP Context Activation message from the network. It also provides control over the use of the V.250
basic commands
ATS0
,
ATA
and
ATH
for handling network requests for PDP context activation.
Parameter Description
0 Disable automatic response for network requests for GPRS PDP context acti-
vation. GPRS network requests are manually accepted or rejected by the
AT+CGANS
command.
1 Enable automatic response for network requests for GPRS PDP context acti-
vation. GPRS requests are automatically accepted according to the description
below.
3 (&F)(P) Modem compatibility mode. The automatic acceptance of both GPRS and
incoming CSD calls is controlled by the
ATS0
command. Manual control uses
the
ATA
and
ATH
commands, respectively, to accept or reject GPRS network
requests or incoming CSD calls.
Notes
• It is allowed to have different
AT+CGAUTO
settings on different interfaces.
• When the
AT+CGAUTO
=0 command is received, the MT will not perform a GPRS detach if it is attached. Sub-
sequently, when the MT announces a network request for PDP context activation by issuing the URC RING
or CRING, the TE may manually accept or reject the request by issuing the
AT+CGANS
command or may sim-
ply ignore the network request.
Test Command
AT+CGAUTO=?
Response(s)
+CGAUTO:
(list of supported
<n>
s)
OK
Read Command
AT+CGAUTO?
Response(s)
+CGAUTO: <n>
OK
Write Command
AT+CGAUTO=
[
<n>
]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 % % % % % % % ! ! !
<n>
(num)