Siemens TC63 - Manual (Page 359)

TC63 AT Command Set
13.25 AT^SMGR
s
TC63_ATC_V00.490 Page 359 of 501 5/24/05
Confidential / Draft - Do not copy
13.25 AT^SMGR Read SMS message without setting status to REC
READ
Syntax
Notes
• The
AT^SMGR
command is a specific Siemens command with the same syntax as
AT+CMGR
Read SMS mes-
sage. The only difference is that the status ''REC UNREAD'' of a short message is not overwritten to ''REC
READ''.
• This command can be used only after the sms data from the SIM have been read successfully for the first
time. Reading starts after successful SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the read process is in progress, an attempt to use any of the sms read
commands will result in ''+CME Error: 14'' (SIM busy)
• We recommend to take advantage of the "^SSIM READY" URC. If enabled with
AT^SSET
, this URC acknowl-
edges to the user that SIM data is accessible after SIM PIN authentication. It will be delivered once the ME
has completed reading data from the SIM card.
Test Command
AT^SMGR=?
Response(s)
^SMGR:
OK
Write Command
AT^SMGR= <index>
Response(s)
see
AT+CMGR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS % % % % % % % ! % !