Siemens TC63 - Manual (Page 36)

TC63 AT Command Set
2.5 ATV
s
TC63_ATC_V00.490 Page 36 of 501 5/24/05
Confidential / Draft - Do not copy
2.5 ATV Set result code format mode
This command determines the contents of header and trailer transmitted with AT command result codes and
information responses. Possible responses are described in Section 2.5.1 , Verbose and numeric result codes .
Syntax
Parameter Description
[0] Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1 (&F) Information response: <CR><LF><text><CR><LF>
Long result code format: <CR><LF><verbose code><CR>
2.5.1 Verbose and numeric result codes
Exec Command
ATV
[
<value>
]
Response(s)
OK
ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 ! % % % % % % ! % !
<value>
(num)(&W)(&V)
Verbose format Numeric format Meaning
OK 0 Command executed, no errors
CONNECT 1 Link established
RING 2 Ring detected
NO CARRIER 3 Link not established or disconnected
ERROR 4 Invalid command or command line too long
NO DIALTONE 6 No dial tone, dialling impossible, wrong mode
BUSY 7 Remote station busy
CONNECT 2400/RLP 47 Link with 2400 bps and Radio Link Protocol
CONNECT 4800/RLP 48 Link with 4800 bps and Radio Link Protocol
CONNECT 9600/RLP 49 Link with 9600 bps and Radio Link Protocol
CONNECT 14400/RLP 50 Link with 14400 bps and Radio Link Protocol
ALERTING Alerting at called phone
DIALING Mobile phone is dialing