Sonic Alert Digital Program Controller DCP301 User Manual
Page 148
Chapter 9. TROUBLESHOOTING
9-6
■
PID set items cannot be displayed by repeatedly pressing
in program setup
state
■
Items cannot be changed by pressing
in program setup state
The pattern item has not been set.
Programming items are set to “display OFF”.
Cause
Remedy
Set SP and time data.
All setup data
C
6
8
to
C
7
1
settings are “1”. Set
necessary items to 0.
■
Event items cannot be displayed by repeatedly pressing
in program setup
state
Event type is controller status event.
Programming items are set to “display OFF”.
Cause
Remedy
Set event type (
E
T
1
,
E
T
2
,
E
T
3
) in event configura-
tion date to one of 0 to 11 or 50.
Set setup data
C
6
8
setting to 0.
■
Time events cannot be displayed by repeatedly pressing
in program setup
state
Time event is assigned to segment No. event.
This model does not support time events.
Programming items are set to “display OFF”.
Cause
Remedy
Change event configuration data
T
T
setting and assign
to time event.
Select a mode that supports time events (option).
Set setup data
C
6
q
setting to 0.
PID set auto-switching is set to ON.
The controller is set to programmer function
by 5G output.
3-position control is selected by 3D output.
Programming items are set to “display OFF”.
Cause
Remedy
Set setup data
C
1
1
setting to 0.
Set setup data
C
1
8
setting to 0.
Set setup data
C
4
5
setting in use to 0 and switch to
PID control from 3-position control.
Set setup data
C
7
0
setting to 0.
■
G.Soak items cannot be displayed by repeatedly pressing
in program setup
state
Programming items are set to “display OFF”.
Cause
Remedy
Set setup data
C
7
0
setting to 0.
■
PV start items, cycle items and pattern link items cannot be displayed by repeat-
edly pressing
in program setup state
Programming items are set to “display OFF”.
Cause
Remedy
Set setup data
C
7
1
setting to 0.