Sonic Alert Digital Program Controller DCP301 - Manual (Page 86)

Chapter 7. PARAMETER SETUP
7-1
Chapter 7. PARAMETER SETUP
7-1 Parameter Setup
Parameters can be set up when the DCP301 is in the basic display state.
If the DCP301 is not in the basic display state, press DISP to set the controller to the basic display state.
■ Selecting the setting group in the parameter setup
Parameter setup is divided into two stages: setting group (major item) and individual
item (minor item).
If you press FUNC + PARA in the basic display state, the display changes to selection of
setting group (major item), the setting group is displayed on the upper display, and the
lower display goes out.
If you press PARA , or , the setting group display changes in order.
Name Remarks
Variable param-
eters
Event configuration
data
PID parameters
Setup data
Table data
Constant-value
operation data
Setting group 1 (major items) selection
Basic Display State
Setting group 2 (major items) selection
Setting group n (major items) selection Individual items
Individual items
Individual items
DISP
key
FUNC + PARA
keys
ENT
key
PARA
key
ENT
key
PARA
key
ENT
key
PARA
key
, , , key
, , , key
, , , key
PARA
key
key
key
PARA
key
key
key
PARA
key
key
key
P A R A
E V
P 1 D
S E T
T B L
C N S T
This parameter is not displayed when variable parameter L O C is 2 or 4
This parameter is not displayed when variable parameter L O C is 2 or 4
This parameter is not displayed when constant-value operation data
M .O D E is 1
This parameter is not displayed when setup data C 1 8 is 1 by 5G output
This parameter is not displayed when setup data C 4 5 is 1 by 3D output
This parameter is not displayed when variable parameter L O C is 1, 2 or 4
This parameter is not displayed when variable parameter L O C is 2 or 4
This parameter is not displayed when variable parameter L O C is 2 or 4
Upper
Display
If you press ENT when the setup group to be selected is displayed, the display moves to
the individual (minor) item level.
The following table shows the setting groups.