Sonic Alert Digital Program Controller DCP301 - Manual (Page 158)

Chapter 10. SPECIFICATIONS
10-3
READY: Ready to run program (control stop/program No. selectable)
RUN: Program run
HOLD: Program hold
FAST: Program fast-forward
END: Program end
AUTO: Automatic operation
MANUAL: Manual operation (output controlled on console)
READY: Ready to run program (control stop)
RUN: Program run
AUTO: Automatic operation
MANUAL: Manual operation (output controlled on console)
Item Specification
Mode
Control
Program operation mode
Constant-value operation
mode
PID control
3-position control
Reverse/direct action
switching
Programmer function
0.0 to 999.9% (0D, 6D output), ON-OFF control by 0.0
0.1 to 999.9% (2G, 5G, 3D, 5K output)
0 to 3600s, PD control by 0
0 to 1200s, PI control by 0
Lower limit: -10.0 to upper limit %
Upper limit: Lower limit to 110.0%
0.0 to 100.0%
8 sets for program operation + 1 set for constant-value
operation
Segment designation/automatic zone selection can be
switched by program operation
0.0 to 10.0%/0.01s, no limit by 0.0
Automatic setting of PID value by limit cycle system +
Neuro & Fuzzy (2 degrees of freedom PID) and Smart
systems (executable by 0D, 2G, 5G and 6D outputs)
0 to 1000U (settable by 0D and 6D outputs)
0.5 to 25.0% (settable by 2G output)
-100.0 to 50.0% (settable by 3D and 5K outputs)
0 to 1000U (settable when 3-position control is selected
by 3D output)
(0D, 2G, 5G, 6D outputs)
MV output can be switched to SP output (5G output).
Supported
1/10000
Proportional band (P)
Rate time (I)
Reset time (D)
MV limit
Manual reset
Number of PID sets
PID set selection
MV change limit
Auto-tuning
ON-OFF control differential
Position-proportional dead
zone
Heat/cool dead zone
Deviation lower limit
Deviation upper limit
Deviation lower limit
hysteresis
Deviation upper limit
hysteresis
Switchable
Switching
Scaling
Output resolution