Sonic Alert Digital Program Controller DCP301 - Manual (Page 87)

Chapter 7. PARAMETER SETUP
7-2
■ Moving individual items in the parameter setup
With individual items, item codes are displayed in the upper display and setting values
are displayed in the lower display.
The program No. display goes out, and the item No. is displayed in the segment No.
display. However, note that the segment No. display also goes out in the case of setup
data.
Individual items are arranged in a matrix as shown on the following page, and can be
displayed in order by pressing
, , or . The size of individual item matri-
ces varies according to the setting group.
■ Changing individual items and how to return from the setup state
If you press
ENT
when an individual item is displayed, the setting value blinks. This state
is referred to as the “setting value entry state.” In this state, pressing or can in-
crement or decrement the setting value that is blinking. Also, pressing or moves
the position of the digit that is blinking.
If you press ENT when the setting value is at the desired value, blinking stops, the display
returns to its normally lit state, and the new setting value is stored to internal memory.
To cancel changing of setting values, press PARA or DISP . When PARA is pressed, the value
stops blinking and the display returns to its normal lit state.
If you press DISP , the display returns to the basic display state. If “- - - -” is displayed at
the lower display when an individual item is displayed, or the controller does not enter
the setting value entry state by pressing
ENT , that item cannot be set nor changed.