Omega RD100B - Manual (Page 106)

5-12
5.3 Setting the Unit on Scaled Channels
Units are set on channels whose input range is set to Scaling, 1-5V, or SQRT.
Procedure
1. Hold down the MENU key for 3 seconds to enter Setting mode.
2. Press the key or SHIFT + key to select Unit and then press the
key.
3. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up
to then are cancelled, and the display returns to a higher level menu.
4. When the Setting complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the ESC key.
5. Hold down the MENU key for 3 seconds to return to Operation mode.
Set the unit.
Set the channel range.
The new setting takes effect.
First channel Last channel
ESC/?
Set=Unit
CH=01-01
Unit=
01-01 Channel
Setting complete
Explanation
Characters That Can Be Used for Units
A unit is set using up to six characters.
The available characters are as follows:
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω, 2 , 3 , .), and space