Omega RD100B User Manual
Page 136
7-13
Setup Operations for Changing/Adding Functions (Basic Setting Mode)
7
Types of Report Data to Be Printed
Changing the Settings
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Hold down the
and
keys simultaneously for 3 seconds to enter Basic
Setting mode.
3.
Press the
key or SHIFT +
key to select Print2 and then press the
key.
4.
Set each item and press the
key.
Use the
key or SHIFT +
key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up
to then are cancelled, and the display returns to a higher level menu.
5.
When the Setting complete screen appears, do either of the following:
Press the
key to set other channels.
If you are done, press the ESC key.
Select the type of report data to print.
Set the channel range.
Select the sum scale.
The new setting takes effect.
ESC/?
First channel Last channel
Printout2
Setting complete
Basic=Print2
CH=01-01
Mode=AVE
SUM scale=Off
Applying the Changes and Returning to Operation Mode
Press the
key or SHIFT +
key to select End and then press the
key. Press
the
key to select Store and then press the
key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the
key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key
to return to the Basic= screen.
7.8 Setting the Periodic Printout Interval and the Type of Measured Values to Be Printed