Omega RD100B - Manual (Page 107)

5-13
Frequently Used Setup Operations (Setting Mode)
5
5.4 Changing the Chart Speed
This section explains the details of changing the chart speed.
Procedure
1. Hold down the MENU key for 3 seconds to enter Setting mode.
2. Press the key or SHIFT + key to select Chart and then press the
key.
3. Set the chart speed and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up
to then are cancelled, and the display returns to a higher level menu.
4. When the Setting complete screen appears, do either of the following:
To correct the setting, press the key.
If you are done, press the ESC key.
5. Hold down the MENU key for 3 seconds to return to Operation mode.
Set the chart speed.
The new setting takes effect.
ESC/?
Set=Chart
mm/h= 20
Chart speed
Setting complete
Explanation
Chart Speed
• Pen Model
The chart speed can be selected from 82 settings shown below.
5 6 8 9 10 12 15 16 18 20
24 25 30 32 36 40 45 48 50 54
60 64 72 75 80 90 96 100 120 125
135 150 160 180 200 225 240 250 270 300
320 360 375 400 450 480 500 540 600 675
720 750 800 900 960 1000 1080 1200 1350 1440
1500 1600 1800 2000 2160 2250 2400 2700 2880 3000
3600 4000 4320 4500 4800 5400 6000 7200 8000 9000
10800 12000
Chart speed on the pen model (unit: mm/h)
• Dot Model
The chart speed can be set in the range of 1 to 1500 mm/h in 1 mm steps.