Omega RD100B - Manual (Page 224)

App-1
Periodic Printout and Printout Using the TLOG Timer (/M1 Option)
App
Appendix
Appendix 1 Periodic Printout and Printout Using the
TLOG Timer (/M1 Option)
Periodic Printout
This section explains the contents of the periodic printout. The periodic printout contents
vary between the pen model and dot model. The contents also vary depending on
whether the periodic printout is in instantaneous mode, report mode, or Off.
Instantaneous mode or report mode is specified using Print1 > Mode in Basic Setting
mode.
The figure below illustrates the printout contents. The font used in the figure differs from that
of the actual printout. The printout positions may also differ from those of the actual printout.
Pen Model
Instantaneous Mode
Time tick cancel mark
Offset compensation mark
Prints the letter “d” for channels set to
delta computation. Alarm Time tick
Unit
Measured
value Channel No.
or tag
Date
Time
Channel data
Computation channel
Scale
Recording color
Chart speed
Mar.31.2004!
15:50*
TAG-001 1.000V
2 -1.000V
3 H-2.1050UNIT03
4 d 2.000V
TAG-00A 1UNIT0A
C L 1.00
D -10.00UNIT0D
E 1.0000%
J -1.00UNIT0J
0.000 2.000
TAG-001
V
RED
50mm/h_
• Date/Time
The date/time when the periodic printout was executed.
• Time tick
Indicates the pen 1 position at the time the periodic printout was executed.
• Time tick cancel mark
Prints an exclamation point (!) when the time tick is not printed correctly.
• Offset compensation mark
Prints an asterisk (*) when offset compensation is enabled.
• Channel data
Prints the channel numbers (1 to 4 or A to J) or tags, measured/computed values, and unit.
Prints the letter “d” on channels set to delta computation.
• Alarm
Prints the alarm that is occurring. If multiple alarms are occurring, the alarm with the
highest precedence is printed.
Alarm printout precedence: (Higher) H, L, T, t, h, l, R, r (Lower)