Omega RD100B - Manual (Page 57)

2-13
Before Using the Recorder
2
Wiring Procedure
The power supply terminals and a protective ground terminal are located on the rear
panel.
1. Turn OFF the recorder and open the transparent power terminal cover.
Screw for fixing the power
terminal cover in place
Power terminal block
Power terminal cover
Open
2. Wire the power cord and the protective ground cord to the power supply
terminals.
Use ring-tongue crimp-on lugs (designed for 4 mm screws).
Philips screwdriver
Crimp-on lug with insulation sleeves
Power cord
Protective ground cord
L
N
3. Replace the power terminal cover, and fasten it with screws.
The proper torque for tightening the screws is 0.6 N-m.
2.5 Power Supply Wiring