TANDBERG 6000MXP - Manual (Page 146)

146
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
CameraTrackingStart Command used to turn
camera tracking on. None None As above xcommand cameratrackingstart
*r Result (status=OK):
*r/end
OK
CameraTrackingStop Command used to turn
cameratracking off. None None As above xcommand cameratrackingstop
*r Result (status=OK):
*r/end
OK
CameraUpgrade Upgrade camera or
video switch with new
software. The software
must be put on a folder
named either /tmp or
/user.
Currently only upgrading
of the first camera
or video switch is
supported. (r) : <1..13> <filename>
Addresses the specific camera or
TANDBERG Video Switch.
Camera software files are named
s01692.pkg.
Video Switch software files are
named s51200.pkg.
None As above xcommand cameraupgrade:1 s01692.pkg
*r Result (status=OK):
*r/end
OK
CameraWhiteBalance Command used to
initiate calibration of
the whitebalance of the
camera. The command
is valid only when the
Camera Whitebalance
Mode is configured to
Manual. Camera (r) : <1..13>
Addresses the specific camera.
None As above xcommand camerawhitebalance camera:1
*r Result (status=OK):
*r/end
OK
ChairRelease Command used to
release chair in a
conference supporting
chair control. None None As above xcommand chairrelease
*r Result (status=OK):
*r/end
OK
ChairTake Command used to take
chair in a conference
supporting chair control. None None As above xcommand chairtake
*r Result (status=OK):
*r/end
OK
CameraTrackingStart — ChairTake