TANDBERG 6000MXP - Manual (Page 164)

164
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
VirtualMonitorReset — VirtualMonitorSet
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
VirtualMonitorReset Command used to
reset a VirtualMonitor.
By resetting a
VirtualMonitor the
system itself retakes
control over what to
be displayed on the
VirtualMonitor. VirtualMonitor (r) : <1..4>
Addresses which VirtualMonitor to
apply the command.
None As above xcommand virtualmonitorreset virtual-
monitor:2
*r Result (status=OK):
*r/end
OK
VirtualMonitorSet Command used to
instruct the system
to display a specific
picture on a specific
VirtualMonitor. A
VirtualMonitor can
be displayed on one
or more of the local
video outputs (which
VirtualMonitor a specific
video output is to
display is configurable).
When this command
is issued for a specific
VirtualMonitor the
picture displayed on this
monitor will not change
until the VirtualMonitor
is reset or set to display
another picture.
VirtualMonitor (r) : <1..4>
Addresses the VirtualMonitor to
which the command is to be applied.
Picture (r) : <LocalMain/LocalDuo/
Still/RemoteMain/RemoteDuo/
JPEG/TandbergMonitor1/
TandbergMonitor2/
PictureProgram1/PictureProgram2/
PictureProgram3/
PictureProgram4/None>
Specifies which of the supported
pictures to display on the addressed
VirtualMonitor.
Call: <1..11>
If RemoteMain or RemoteDuo is
selected, this parameter must be
supplied to select the correct remote
call.
None As above xcommand virtualmonitorset virtualmoni-
tor:2 picture:still
*r Result (status=OK):
*r/end
OK