TANDBERG 6000MXP - Manual (Page 157)

157
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
FloorToSite Command used to
assign floor to a specific
site in a MultiSite
conference supporting
H.243. MCuID (r) : <1..191>
MCUID to the MultiSite the site is
connected to.
TerminalID (r) : <1..191>
The site’s terimnal id, referenced to
the MultiSite it is connected to.
None As above xcommand floortosite mcuid:85 terminal-
id:2
*r Result (status=OK):
*r/end
OK
FloorToSiteEnd Command used to end
the assignment of floor
to a specific site in a
MultiSite conference
supporting H.243.
Requires that the
command FloorToSite
has been issued in
advance None None As above xcommand floortositeend
*r Result (status=OK):
*r/end
OK
GroupEntryAdd Command used to add
a new Group entry to
the locally stored Group
Directory (or MultiSite
Directory). The entry is
stored in the first vacant
position in the Group
Directory. Name: <S: 0, 48>
The entry’s name.
LocalEntryId.1..10: <1..200>
References to local entry ids to be
included in this Group entry.
GroupEntryId:
<1..50>
Reference to the
Group Directory
position the entry
is stored. As above xcommand groupentryadd name:”My Group
Entry” localentryid.1:1 localentryid.2:7
localentryid.3:9
*r Result (status=OK):
GroupEntryId: 17
*r/end
OK
GroupEntryDelete Command used to
delete an entry in the
locally stored Group
Directory. GroupEntryId (r) : <1..50>
Reference to the entry to delete.
None As above xcommand groupentrydelete groupentryid:30
*r Result (status=OK):
*r/end
OK
KeyDown Command used to
emulate pressing a key
on the TANDBERG MXP
remote control without
releasing it. The KeyDown
command should be
followed by a KeyRelease
command to emulate
releasing the key. Key (r) : <0/1/2/3/4/5/6/7/8/
9/*/#/Connect/Disconnect/
up/Down/Right/Left/Selfview/
Layout/Phonebook/Cancel/
MicOff/Presentation/Volumeup/
VolumeDown/OK/ZoomIn/
ZoomOut/Grab>
None As above xcommand keydown key: phonebook
*r Result (status=OK):
*r/end
OK
FloorToSite — KeyDown