TANDBERG 6000MXP - Manual (Page 162)

162
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
ScreensaverDeactivate Command used to
deactivate screensaver.
NOTE: Warranty will
be void if used with
TANDBERG systems
shipped with Plasma
monitors.
None None As above xcommand screensaverdeactivate
*r Result (status=OK):
*r/end
OK
ScreensaverReset Command used to reset
the screensaver timer. Delay (r) : <1..480>
Specifies the screensaver delay in
minutes.
None As above xcommand screensaverreset delay:90
*r Result (status=OK):
*r/end
OK
SiteDisconnect Command used to
disconnect a specific
site from a MultiSite
conference supporting
H.243. MCuID (r) : <1..191>
MCUID to the MultiSite the site is
connected to.
TerminalID (r) : <1..191>
The site’s terimnal id, referenced to
the MultiSite it is connected to.
None As above xcommand sitedisconnect mcuid:85 termi-
nalid:2
*r Result (status=OK):
*r/end
OK
SiteView Command used to
requset view of a
specific site in a
MultiSite conference
supporting H.243. MCuID (r) : <1..191>
MCUID to the MultiSite the site is
connected to.
TerminalID (r) : <1..191>
The site’s terimnal id, referenced to
the MultiSite it is connected to.
None As above xcommand siteview mcuid:85 terminalid:2
*r Result (status=OK):
*r/end
OK
SiteViewEnd Command used to end
viewing of a specific
site in a MultiSite
conference supporting
H.243. Requires that
the SiteView command
has been issued in
advance. None None As above xcommand siteviewend
*r Result (status=OK):
*r/end
OK
ScreensaverDeactivate — SiteViewEnd