TANDBERG 6000MXP - Manual (Page 76)

76
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
Conference Downspeed: <On/Off>
Determines whether or not to allow downspeeding.
Example: xconfiguration conference downspeed: on
Conference FallbackToTelephony: <On/Off>
If set to On, the system will try to establish a telephone call if a video telephone call failed to connect.
Example: xconfiguration conference fallbacktotelephony: on
Conference Encryption Mode: <On/Off/Auto>
If set to On, the system will not allow unencrypted calls.
If set to Auto, the system will use encryption whenever possible.
If set to Off, encryption will not be used.
Example: xconfiguration conference encryption mode: auto
Conference Encryption Type: <Auto/DES/AES-128>
Defines the encryption algorithm to use.
If set to Auto, the system will try to use the most secure encryption - AES, dependent on the capabilities of the other sites. For sites that do not support
AES encryption, DES encryption will be tried.
If set to AES-128, the system will try to use AES with 128 bits encryption when setting up calls. If AES is not supported by the other site(s), no other type
of encryption will be initiated.
If set to DES, the system will always try to set up the call using DES with 56 bits encryption on ISDN and IP. If all other sites do not support DES, no other
type of encryption will be initiated.
Example: xconfiguration conference encryption type: AES-128
Conference AIM: <On/Off>
Enables/disables Auto Indicate Mute. If disabled, the system will not signal to the other side that the microphone is turned off.
Example: xconfiguration conference aim: on
Conference IPLR Transmit: <On/Off>
Enables/disables Intelligent Packetloss Recovery
Example: xconfiguration conference iplr transmit: on
Conference WebSnapshots: <On/Off>
If set to On, snapshots of the conference can be viewed from the systems web interface and also accessed through the units file system.
NOTE! This configuration can only be set using the RS232 port.
Example: xconfiguration conference websnapshots: on
Conference BillingCode: <On/Off>
This configuration is only relevant when when placing calls using the TANDBERG remote control and the on screen menu. If set to on, all users must enter a code to identify
themselves before dialling. The billing code will be attached to the call when the call is placed in the call log after it is disconnected. When placing calls using the command Dial,
a billing code can be added to identify the call in the call log regardless of this setting.
Example: xconfiguration conference billingcode: on
Conference
cont...