TANDBERG 6000MXP - Manual (Page 92)

92
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
ISDN PRI NSFTelephony Number: <0..31>
Defines what Service Facility to use for telephony if the NSFTelephony Mode is set to On.
Example: xconfiguration isdn pri nsftelephony number: 8
Service profiles for Sprint (ref. 2):
NSF Service
0 Reserved
1 Private
2 Inwatts
3 Outwatts
4 FX
5 TieTrunk
Service profiles for MCI (ref. 3):
NSF Service
1 VNET/Vision
2 800
3 PRISM1, PRISMII, WATS
4 900
5 DAL
Service profiles for AT&T (ref.1):
NSF Service
0 Disable
1 SDN (including GSDN)
2 Toll Free Megacom (800)
3 Megacom
6 ACCUNET Switched Digital Service (including Switched Digital International)
7 Long Distance Service (including AT&T World Connect)
8 International Toll Free Service (I800)
16 AT&T MultiQuest
23 Call Redirection Service
ISDN PRI NSFVideoTelephony Mode: <On/Off>
Enables/disables use of NSF for videotelephony. NSF = Network Service Facility
Example: xconfiguration isdn pri nsfvideotelephony mode: on
ISDN PRI NSFVideoTelephony Number: <0..31>
Defines what Service Facility to use for videotelephony if NSFVideoTelephony Mode is set to On.
Example: xconfiguration isdn pri nsfvideotelephony number: 8
ISDN PRI SwitchType: <NI/ATT/Euro/Japan>
Selects the type of PRI switch the system is connected to.
Example: xconfiguration isdn pri switchtype: ni
ISDN PRI InitialRestart: <On/Off>
When restart is set to on the PRI interfaces will be reinitialized after boot.
Example: xconfiguration isdn pri initialrestart: on
ISDN PRI Alert: <On/Off>
If set to On, the system will respond with an alert message to all incoming setup messages. If set to Off (default) the system will respond with an alert
message only to the incoming setup message related to the initial channel. If, in addition, the PBX requires this signalling you will only get connected on
the first incoming channel.
Example: xconfiguration isdn pri alert: on
ISDN PRI ChanId: <On/Off>
Can be used to force sending of channel id information. When set to “on”, the system will signal to the PBX which PRI channels is used for the call.
Default setting is Off. Note: This setting must be set to On, to work with an Ericsson MD110 PBX.
Example: xconfiguration isdn pri chanid: on
ISDN
cont...