Defaultvaluesset, Defaultvalueset – TANDBERG 6000MXP User Manual
Page 151
151
TANDBERG 3000
MXP
&
6000
MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an
(r)
appended to the parameter name. The
(r)
appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command
Description
Parameters
Result parameters
when OK
Result parameters
when error
Example
DefaultValuesSet
Command used to reset
configurations to factory
default values.
Level: <1..3>
Configurations are divided into
three different storage levels.
The level parameter denotes that
configurations on this level and all
levels below (lower value) are to be
reset.
The complete list of Storage Levels
can be found in
.
None
As above
xcommand defaultvaluesset level:2
*r Result (status=OK):
*r/end
OK
DefaultValueSet