TANDBERG 6000MXP - Manual (Page 170)

170
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Status Information – xstatus /xstatus.xml
D 13887.08
MAY 2008
Status information followed by a
*
will not be shown unless Detailed Level has been set to 2 – see XACLI – Special commands – xpreferences
Call [1..10] (status= Disconnected / CallIDLE / Dialing / Alerting / Proceeding / EstablOut / EstablIn / AwaitInCnf / Connected / Disconnecting / Await2ndnr / ClearOut / ClearIn / Syncing / Capex / Synced / Unframed ,
type = NA / Tlph / Vtlph ,
protocol = NA / ISDN / H320 / H323 / SIP,
direction = NA / Incoming / Outgoing ,
logTag = 1..x )
If status = Disconnected
and type = NA
and protocol = NA
and direction = NA
and logtag = x
the following will be included:
Cause:
If status = Dialing / Alerting / Proceeding / EstablOut / EstablIn / AwaitInCnf / Connected / Disconnecting / Await2ndnr / ClearOut / ClearIn / Syncing / Capex / Synced / Unframed
and type = Tlph
and protocol = ISDN
and direction = Incoming / Outgoing
and logTag = x
the following will be included:
CallRate: 64
RemoteNumber [1..2]:
RemoteSubAddress:
IncomingNumber:
Appears for incoming calls only
IncomingSubAddress:
Mute: On/Off
Microphone: On/Off
Duration: 0...
MuteOutgoing: On/Off
Channels [1..2] (type = Incoming / Outgoing ) :
If type = incoming / outgoing the following will be included:
Rate: 64
Restrict: On/Off
Audio (status = Active / Inactive ) :
Call