TANDBERG 6000MXP - Manual (Page 90)

90
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
IPMedia MaxVideoTXRate: <64..4096>
The MaxVideoTXRate (kbps) defines the desired maximum transmitted call rate for IP calls. This is to be able to limit the outgoing bandwidth
whilst keeping the maximum incoming bandwidth, especially useful for home offices with different upstream and downstream rates, typically ADSL.
Example: xconfiguration ipmedia maxvideotxrate: 384
IPProtocol: <IPv4/IPv6/Both>
Defines what IP protocol to use. If set to Both the system will support both IPv4 and IPv6.
Example: xconfiguration ipprotocol: both
IRControl Mode: <On/Off>
Enables/disables the TANDBERG Remote Control.
Example: xconfiguration ircontrol mode: off
IRControl NumberKeyMode: <AddCall/DTMF/Presets/Manual>
When pressing a number key on the remote control, while in a call, the user can decide what shall happen. The system can be configured to act automatically or manually.
Please refer to the Endpoint User Guides for further details.
Example: xconfiguration ircontrol numberkeymode: DTMF
ISDN CliNumbSpec: <On/Off>
Explicitely specify Calling Party Number fields Type/Plan to be used in outgoing calls in the ISDN setup message. Using default values if set to Off. When set to on, the system
will use the values set by “ISDN ClinNumPlan” and “ISDN ClinNumbType”.
Example: xConfiguration isdn clinumbspec: Off
ISDN CliNumbType: <0..6>
Value to be used for Calling Party Number field Type. If the value is set to 2, the number type in the setup message will be set to National. This is required in the UAE.
Example: xConfiguration isdn clinumbtype: 5
ISDN CliNumbPlan: <0..14>
Value to be used for Calling Party Number field Plan in the ISDN setup message. If the value is set to 1, the numbering plan in the setup message will signal ISDN. This is re-
quired in UAE.
Example: xConfiguration isdn clinumbplan: 12
ISDN SendComplete: <On/Off>
If set to On the system will send the ISDN message information element Sending Complete.
If set to Off The system will not send Sending Complete. Default is Off.
Example: xconfiguration isdn sendcomplete: on
ISDN SendNumber: <On/Off>
When set to On, the system will send its own numbers to the far end.
When set to Off, the system will not send its own numbers to the far end, but please note that the network may still send your numbers to the far end.
Example: xconfiguration isdn sendnumber: on
IPMedia — ISDN