HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 114)

Setting up parallel execution of verification processes for Exchange database
backup
When an Exchange database is being backed up, you can specify the number of verification processes
that are executed in parallel during VSS backup, using the following parameter.
Table 22 Parameter in init.conf (setup of parallel execution of verification processes)
Default
(specifiable
value)
Description Parameter
1
(1-32)
Specify the number of verification processes to be executed in parallel
during VSS backup. Specify this parameter in the
init.conf file
for the backup server.
For executing VSS backup from multiple database servers to a single
backup server simultaneously, if you specify a value of 2 or greater
for this parameter, the verification processes are executed in parallel.
If the parameter is not specified, 1 is applied.
VERIFY_PARAL-
LEL_COUNT
If the number of VSS backups specified exceeds the value specified for
VERIFY_PARALLEL_COUNT
,
the excess VSS backups wait until other VSS backups are completed.
NOTE:
For VERIFY_PARALLEL_COUNT , specify a value that is equal to or less than the number of backup
server disk I/O routes.
Setting communication timeout periods for the Protection Manager service
When an Exchange database is being backed up, you can specify the communication timeout period
for the Protection Manager service, using the following parameter.
Table 23 Parameter in init.conf (setting the communication timeout period for the Protection Manager
service)
Default
(specifiable value)
Description Parameter
1440
(0-10080)
Specify a number of minutes for the Protection Manager service
communication timeout period. If 0 is specified, no timeout is set.
In this case, if the Protection Manager service does not return a
response, the command that requested processing from the
Protection Manager service remains in the standby state.
If the parameter is not specified, 1440 is applied.
SER-
VICE_TIMEOUT
By specifying a communication timeout period for the Protection Manager service, you can avoid the
situation in which a Application Agent command remains in standby status and never terminates.
Preparation for using Application Agent 114