HP Serveur lame HP ProLiant BL465c Gen8 User Manual
Page 120
specify any purpose-specific parameters, the values of
RETRY_TIME
and
RETRY_WAIT
are used.
The following table shows the parameters you can add.
Table 27 Parameters in the RAID Manager-linkage definition file (DEFAULT.dat) (to specify the retry
count and interval for checking the pair status according to the purpose)
Specifiable val-
ues
(default)
Description
Parameter
0 to 3600
(Value of
RETRY_TIME
)
Specifies the maximum number of retries for
checking the completion of pair
resynchronization.
Specify this parameter to check the pair status
to make sure that backup processing or
resynchronization finishes (the completion of
paircreate
#1
or
pairresync
).
If you specify 0, Application Agent continues
to retry checking until it succeeds in checking
the status.
When adding this parameter, make sure that
the product of the RESYNC_RETRY_TIME-value
and RESYNC_RETRY_WAIT-value is sufficiently
larger than the time required to complete pair
creation.
RESYNC_RETRY_TIME
0 to 360000
(Value of
RETRY_WAIT
)
Specifies the retry interval (in 10 milliseconds)
for checking the completion of pair
resynchronization.
Specify this parameter to check the pair status
to make sure that backup processing or
resynchronization finishes (the completion of
paircreate
#1
or
pairresync
).
When adding this parameter, you must
consider the following: the number of disks to
be backed up or resynchronized, the disk sizes,
and the difference in data amounts between
the primary and secondary volumes at the time
the operation is performed
#2
.
Generally the required time of the
resynchronization processing is larger than that
of the splitting processing, specify
RESYNC_RETRY_WAIT >
SPLIT_RETRY_WAIT
for the value.
RESYNC_RETRY_WAIT
Preparation for using Application Agent
120